12
2.
Adjust upper handle assembly to the optimal position by
aligning the double bolt holes at the desired height. Secure
the connection using the 4 handle knobs and bolts, and
tighten on each side (Fig. 9).
Discharge Chute Assembly
1.
Place the discharge chute assembly onto the gear plate,
and push down until the chute is flush and flat against the
housing (Fig. 10).
2.
With the holes on the discharge chute pole aligned with
the holes on the housing, use the 12 mm open end wrench
to secure the 2 chute bolts with the discharge chute
assembly (Fig. 11).
3.
Clip the cord clip onto the lower handle frame, insert the
discharge chute cable into the cord clip (Fig. 12).
Co Features
m
WARNING!
AVOID INJURY. Read and understand the
entire safety section before proceeding.
Snow blower controls and features are described below and
illustrated in Fig. 13.
Control Panel (Fig. 13)
Fig. 8
Upper
handle
assembly
Handle
knob +
bolt
Lower
handle
Fig. 9
2-position handle
height adjustment
1
2
Fig. 10
Discharge
chute assembly
Gear plate
Fig. 11
Discharge
chute pole
Chute bolts
12 mm wrench end
Fig. 12
Discharge
chute cable
Cord clip
Fig. 13
Auger speed
control lever
LED switch
Reverse
button
Drive speed
control lever
Chute
control lever
Reverse indicator LED
