1. Getting To Know Your New Z-Wave Device
•
Dimming light manually or remotely via the Z-Wave controller
•
Can be Included in multiple Groups and Scenes
•
Compatible with all incandescent and CFL/ LED bulbs
•
Z-Wave Certified for simple pairing and integrated home automation
•
Screw Terminal Installation
—
requires wiring connections for Line (Hot), Load, Neutral.
WARNING
—
SHOCK HAZARD
Turn OFF the power to the branch circuit for the dimmer and lighting fixture at the service panel. All wiring
connections must be made with the power OFF to avoid personal injury and/or damage to the switch.
A. Up Push button
B. Down Push button
C. Nutral (White) - Nutral in
D. Line (Black) - Line in
E. Load (Black)
Single switch wiring
1. Shut off power to the circuit at circuit breaker or fuse box.
IMPORTANT!
Verify power is OFF to switch box before continuing.
2. Remove wall plate.
3. Remove the dimmer mounting screws.
4. There are up to three screw terminals on the dimmer; these are marked
C. Nutral
—
White(Nutral)
D. Line
—
Black (connected to power)
E. Load
—
Black (connected to lighting)
5. Observe Important Wiring Information
IMPORTANT!:
This dimmer is rated for and intended to only be used with copper wire. Wire Gauge Requirements
Use larger wires suitable for at least 80
°
C for supplying Line (HOT), Load, Neutral connections.
Use larger wires suitable for at least 80
°
C for supplying Line (HOT), Load, Neutral connections.
Wire strip length:
For attachment to screw terminals: Strip insulation 1" , For attachment using the enclosure
’
s holes: Strip
insulation 5/8".
6. Connect the black wire that goes to the light to the terminal marked Load.
7. Connect the black wire that comes from the electrical service panel (Hot) to the terminal marked Line.
8. Connect the white wire to the neutral terminal marked Nutral (use jumper wire if needed).
9. Insert dimmer into the switch box being careful not to pinch or crush wires.
10. Secure the dimmer to the box using the supplied screws.
11. Mount the wall plate.
12. Reapply power to the circuit at fuse box or circuit breaker and test the system.
Basic Operation
The connected light can be dimming in two ways,
1. Manually from the front button of the In-wall dimmer
2. Remotely with a Z-Wave Controller
Manual Control
The Front button allows the user to:
dim the connected fixture.
To dimming the connected light bright: Press the Up push button.
To dimming the connected light dark: Press the Down push button.
2. Linking your Z-Wave device
Reset your dimmer to factory default:
Use controller to remove device from network will reset it to factory default.
Please use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Adding device into the network:
1. Follow the instructions of certified controller to include a device from different manufactures into the Z-Wave network.
2. Once the controller is ready to include your device, triple press the Up/Down push button to include it
into the network.
