Showgear E748000, User Manual

Page: 12 / 16

11
Tree & Pole Bracket
Product code: E748000
5. Inspection and Maintenance
Attention
Inspection and maintenance may be carried out only by instructed or skilled persons.
Service shall be carried out only by skilled persons.
Inspection
Attention
Inspect the device visually for any defects.
Before and after every use, examine the device visually for any defects. During use, inspect the device at
regular intervals according to the inspection schedule established for the site.
If any fault is found, mark the device clearly and remove it from service.
● Examine the device for damage, cracks and corrosion.
● Examine the welds for signs of corrosion and cracks.
The device is supplied with 2 endless ratchet straps.
● Examine the endless ratchet straps for signs of wear. Do not use the endless ratchet straps if there are
tears, cuts, nicks and breaks in the webbing and the retaining stitches.
● Examine the ratchet for deformations, splits, signs of wear, and signs of corrosion.
Corrective Maintenance
● Do not modify the device.
● Refer repairs and servicing to skilled persons. Contact your Highlite International dealer for more
information.
Basic Cleaning Instructions
● Use a damp cloth to clean the device.
● Do not use alcohol, solvents or abrasive agents.
● Wash the endless ratchet straps in water and hang them to dry at a well ventilated place.
6. Deinstallation, Transportation and Storage
Instructions for Deinstallation
WARNING
Incorrect deinstallation can cause serious injuries and damage of property.
● Restrict the access under the working area during deinstallation.
● Always observe the national and site-specific regulations during deinstallation of the device.
● Wear personal protective equipment in compliance with the national and site-specific regulations.
Deinstall the external device.
Loosen both ratchets (03). See 6.1.1. Loosening of the Ratchet on page 12 for more information.
Deinstall the Tree & Pole Bracket and remove the endless ratchet straps (04).