4
STEP 6
Lift and place the enclosure onto the tray, seek assistance
should you require it. The enclosure should sit with an even
gap all along the front of the tray with no part overhanging.
Line up the enclosure with the pre drilled holes in the walls.
Using the 65mm countersunk screws (
N
) fix through the
enclosure sides into the fitted wall plugs.
Issue 1 - 07/11
N
STEP 5
N
N
N
N
N
N
N
N
With the tray level, centre the enclosure within the wall channels and ensure the frame is vertical.
Note:
Make certain that the frame profile is not bowed on either side. Also check down the length of the unit on the handle side
that the main seal flipper is making full contact with the glass edge (see illustrations above).
From inside the enclosure, drill through the eight holes in the side profiles (as shown) into the wall channels using the .9mm drill
bit supplied (
Q
).
Fix the sections together using the 9.5mm pan head screws (
L
) and push-fit screw covers (
R
).
STEP 7
Q
Q
Q
Q
R
L
Ø 2.9mm
Q
Check for
bow.
Check for
bow.
Q
Q
Main Seal Flipper.
Dry/outside enclosure.
Wet/inside enclosure.
Main Seal Flipper.
Correct set-up
for handle side
of pivot door.
Incorrect set-up
for handle side
of pivot door.
Glass.
Glass.
Q
Q
Attach the door handle (
I
) to the door as shown above.
N.B. Linea Touch Handle:
Please ensure that the door knob
on the inside is in the top position as shown above.
I
Inside
Outside
Door Knob
I
Inside
Outside
LINEA TOUCH HANDLE
GLIDE HANDLE
