easy assembly. The
Pump/Handle Assembly
and the
Tank Assembly
have been shipped in two boxes to minimize shipping damage.
Orient the
Pump/Handle Assembly
and the
Tank Assembly
as
shown in
fi gure 1
. Slide the two assemblies together so that the Side
Holes line up, then insert a 3/8 Bolt, Washer & Nut at each side, fi nger
tight.
Now insert a 3/8 Bolt & Washer up from the back and a Nut from
the top side, then repeat for the other side.
Tighten fi rmly all of the 3/8
Bolts & Nuts using the Universal Assembly Tool.
Attach the Pump H3-Y Hose to the Tank by sliding the Quick
disconnect onto the fi tting on the tank. Make sure that the Quick connector
clicks in place and is fi rmly seated.
Slide the Quick disconnect of the
Long H2 Hose Assembly onto the
fi tting on the pump as shown. Make
sure that the Quick connector clicks
in place and is fi rmly seated.
Lastly, attach the crank handle
onto the Pump Shaft as shown in
fi gure 2
. Be careful that the bolt is lined up with the hole
in the side of the pump shaft. Firmly tighten
the bolt.
Caution: Overtightening will break
the handle.
This completes the assembly of the
Shortening Shuttle
®
Pump
.
Please read the
next section to learn how to operate the unit
safely.
4
fi gure 1
fi gure 2