SM - 14
Summary Manual
Mark V Model 520
ADJUST THE WORKTABLE'S 45°
STOPS
32.
Loosen the table height lock and raise the table
until it clears the saw blade. Tighten the
height lock.
33.
Loosen the tilt lock and tilt the worktable to
the right until it makes contact with the two
45° stop bolts.
34.
Tighten the tilt lock only enough to allow
movement with firm pressure.
35.
Loosen the quill feed (shown in Figure B-68)
and extend the quill so the saw blade is cen-
tered beneath the slot in the table insert. When
it is centered, lock the quill feed.
38.
If the worktable is not exactly 45° to the saw
blade, adjust the worktable so it is.
39.
Tighten the tilt lock, then use a 1/2" wrench to
adjust the 45° stop on the front side of the
worktable (shown in Figure B-71) and the
back side of the worktable (shown in Figure B-
72). The stops should just contact the under-
side of the table.
40.
Loosen the tilt lock and move the table. To
recheck the 45° stops, repeat Steps 35 through
39. (It is very important to recheck the set-
ting!)
ALIGN THE MITER GAUGE SLOTS
41.
Return the worktable to the horizontal "0"
stop and tighten the tilt lock. The carriage lock
and headstock lock should also be tightened.
Remove the table insert.
42.
Place the miter gauge in the right miter gauge
slot, and use a 5/32" Allen wrench to remove
the quick clamp from the safety grip, as shown
in Figure B-73.
36.
Lower the worktable so the saw blade extends
through the slot. See Figure B-69. Lock the
table height.
37.
Remove the blade from the combination square
and place the square against the saw blade
and the worktable, as shown in Figure B-70.
Make sure the combination square doesn't
rest on the table insert.
Figure B-68
Figure B-69
Figure B-70
Figure B-71
Figure B-72
Figure B-73