Adjustments
Tiller Angle Adjustment
On the left side of the base of the tiller
there is a red lever. Push the lever in to
release the pin and select the required
tiller angle.
When the desired angle is set, refit the pin
into one of the three lower locating holes.
Caution! Ensure the tiller is properly
locked into position before driving the
scooter.
Seat Depth Adjustment
The seat in the scooter can be
adjusted for depth and swivel to
allow easy access/exit.
To adjust the depth, pull the seat
slide lever upwards, move the
seat to the required position and
release the lever.
Under the right side of the seat
there is a red lever. Pulling up on
the lever allows the seat to swivel.
Seat Height Adjustment
To adjust the height of the seat, undo
the seat-tightening knob under the front
of the seat.
Pull the swivel adjustment lever
upwards and at the same time lift the
seat from the adaptor.
Remove the seat height-locating pin and
set the seat adaptor to the desired
height and reset the locking pin.
Reverse the above instructions to
replace the seat and re-tighten the hand
knob.
Mirror Fitment
The scooter is supplied with two side mirrors which
need to be fitted. Take the 17mm nyloc nut and
washer off the mirror stem, open the door and put
the threaded end through the side window from the
outside. Re-apply the washer and nut and gently
tighten until the mirror is steady. Make any final
adjustments and gently tighten ‘hand tight’.
Caution: DO NOT overtighten the inner nut
against the window as this may cause damage.
5
