OPERATION
Follow these instructions to operate your air mover:
1. Unpack air mover from carton.
2. To use your unit, place the unit in the area most suitable for your application. Several factors need to be considered; the unit must be placed
close enough to an AC outlet to be plugged in, there must be a minimum clearance of two feet from either side of the unit to allow for proper
air flow, and the unit should not be placed where it can become a tripping or safety hazard.
3. Place unit in the proper operating position for your application. Refer to the Operating Positions section in this manual.
4. Plug unit into the wall.
5. Turn unit on and select air speed by turning the switch, located near the top handle, clockwise.
6. When your drying job is completed, turn the unit off and follow the directions for Storage in this manual.
WARNING -
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS AIR MOVER
WITH ANY SOLID-STATE SPEED CONTROL DEVICE.
OPERATING POSITIONS
The air mover may be set in one of three operating positions. Pick the position best suited for your application.
1. Use the down position
(Figure 1)
for applications such as; drying wet floors, shampooed carpets, etc. To use this position simply place unit
on its base.
2. Use the angle position
(Figure 2)
for applications such as, drying plaster on walls or drying wet furniture. To use this position, tilt unit
backwards so it rests on the support.
3. Use the up position for applications such as; drying paint on the ceiling. To use this position, lay the unit on the back side with the front grill
pointing towards the ceiling
(Figure 3).
CLEANING
USER SERVICING INSTRUCTIONS
LUBRICATION
WARNING -
TO REDUCE THE RISK OF INJURY FROM THE AIR MOVER ACCIDENTALLY STARTING,
UNPLUG POWER CORD BEFORE CLEANING.
The outside of the unit may be cleaned with a damp cloth to remove any dust or residue.
WARNING -
BE SURE TO DISCONNECT POWER SUPPLY BEFORE ATTEMPTING TO SERVICE OR
REMOVE ANY COMPONENTS.
Do not attempt to service your air mover beyond that described in the user manual.
No lubrication is necessary as the motor is equipped with lifetime lubricated bearings.
1
2
3
1. Before storing your air mover it should be cleaned. For cleaning instructions, refer to the Cleaning section in this manual.
2. Wrap the power cord around the carry handle on the top of the unit to keep it untangled
(Figure 4).
3. If you have more then one unit to store they may be stored by stacking them. Stack the units by placing them on their sides making sure the
indented side is facing down
(Figure 5).
Do not stack the units more then 4 high. Never operate the unit while it is on its side or stacked.
THE
AIR MOVER SHOULD BE STORED INDOORS.
STORAGE
4
5
87548-36
