NOTE:
STATIC SHOCKS ARE COMMON
IN DRY AREAS OR WHEN THE RELATIVE
HUMIDITY OF THE AIR IS LOW. THIS IS
ONLY TEMPORARY AND DOES NOT AFFECT
THE USE OF THE APPLIANCE. TO REDUCE
THE FREQUENCY OF STATIC SHOCKS
IN YOUR HOME, THE BEST REMEDY IS
TO ADD MOISTURE TO THE AIR WITH A
CONSOLE OR INSTALLED HUMIDIFIER.
This appliance is for use on a nominal
120-volt circuit, and has a grounded
plug that looks like the plug illustrated in
sketch A
. A temporary adaptor that looks
like the adaptor illustrated in
sketches
B and C
may be used to connect this
plug to a 2-pole receptacle as shown in
sketch B
if a properly grounded outlet
is not available. The temporary adaptor
should be used only until a properly
grounded outlet
(sketch A)
can be installed by a qualified electrician. The green colored rigid
ear, lug or the like extending from the adaptor must be connected to a permanent ground
such as a properly grounded outlet box cover. Whenever the adaptor is used, it must be held
in place by a metal screw.
IN CANADA, THE USE OF A TEMPORARY ADAPTOR IS NOT PERMITTED BY THE CANADIAN
ELECTRICAL CODE. Make sure that the appliance is connected to an outlet having the same
configuration as the plug. No adaptor should be used with this appliance.
This appliance must be grounded. If it should malfunction or break down, grounding provides
a path of least resistance for electric current to reduce the risk of electric shock. This
appliance is equipped with a cord having an equipment-grounding conductor and grounding
plug. The plug must be inserted into an appropriate outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
WARNING
– IMPROPER CONNECTION OF THE
EQUIPMENT-GROUNDING CONDUCTOR CAN RESULT IN A RISK OF
ELECTRIC SHOCK. CHECK WITH A QUALIFIED ELECTRICIAN OR SERVICE
PERSON IF YOU ARE IN DOUBT AS TO WHETHER THE OUTLET IS
PROPERLY GROUNDED. DO NOT MODIFY THE PLUG PROVIDED WITH THE
APPLIANCE – IF IT WILL NOT FIT THE OUTLET, HAVE A PROPER OUTLET
INSTALLED BY A QUALIFIED ELECTRICIAN.
GROUNDING INSTRUCTIONS
UNPACKING AND SET-UP
1. Remove the tank cover by pushing in the side lugs with thumbs and lifting up on the tabs
of the tank cover. Remove any accessories, which may have been shipped in the tank.
2. Before replacing tank cover, refer to Dry Pick Up Operation or Wet Pick Up Operation in this
manual to ensure you have the proper filters installed for your cleaning operation.
3. Replace tank cover on the tank by aligning tabs with the lugs. Press down firmly on the
upper housing until tank cover snaps into place.
When using the appliance at a distance where an extension cord becomes necessary, a
3-conductor grounding cord of adequate size must be used for safety, and to prevent loss
of power and overheating. Use the table below to determine A.W.G. wire size required.
To determine ampere rating of your vacuum, refer to nameplate located on rear of motor
cover. Before using appliance, inspect power cord for loose or exposed wires and damaged
insulation. Make any needed repairs or replacements before using your appliance. Use only
three-wire outdoor extension cords which have three-prong grounding-type plugs and three-
pole receptacles which accept the extension cord’s plug. When vacuuming liquids, be sure the
extension cord connection does not come in contact with the liquid.
EXTENSION CORDS
When using an electrical appliance, basic precautions should always be followed, including
the following:
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.
WARNING
– TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR INJURY:
1. Do not leave appliance when plugged in. Unplug from outlet when not in use and before
servicing. Connect to a properly grounded outlet only. See Grounding Instructions.
2. Do not expose to rain – store indoors.
3. Do not allow to be used as a toy. Close attention is necessary when used by or near
children.
4. Use only as described in this manual. Use only Manufacturer’s recommended
attachments.
5. Do not use with damaged cord or plug. If appliance is not working as it should, has been
dropped, damaged, left outdoors or dropped into water, contact Shop-Vac Corporation for
assistance.
6. Do Not: pull or carry by cord, use cord as a handle, close a door on cord or pull cord
around sharp edges or corners. Do not run appliance over cord. Keep cord away from
heated surfaces.
7. Do not unplug by pulling on cord. To unplug, grasp the plug: not the cord.
8. Do not handle plug or appliance with wet hands.
9. Do not put any object into openings. Do not use with any openings blocked; keep free of
dust, lint, hair and anything that may reduce air flow.
10. Keep hair, loose clothing, fingers and all parts of body away from openings and moving
parts.
11. Do not pick up anything that is burning or smoking, such as cigarettes, matches or hot
ashes.
12. Do not use without dust bag and/or filters in place.
13. Turn off all controls before unplugging.
14. Use extra care when cleaning on stairs.
15. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas
where they may be present.
16. Do not use your cleaner as a sprayer of flammable liquids such as oil base paints,
lacquers, household cleaners, etc.
17. Do not vacuum toxic, carcinogenic, combustible or other hazardous materials such
as asbestos, arsenic, barium, beryllium, lead, pesticides or other health endangering
materials. Specially designed units are available for these purposes.
18. Do not pick up soot, cement, plaster or drywall dust without cartridge filter and collection
filter bag in place. These are very fine particles that may pass through the foam and
affect the performance of the motor or be exhausted back into the air. Additional
collection filter bags are available.
19. Do not leave the cord lying on the floor once you have finished the cleaning job. It can
become a tripping hazard.
20. Use special care when emptying heavily loaded tanks.
21. To avoid spontaneous combustion, empty tank after each use.
22. The operation of a utility vac can result in foreign objects being blown into eyes, which
can result in eye damage. Always wear safety goggles when operating vacuum.
23.
STAY ALERT.
Watch what you are doing and use common sense. Do not use vacuum
cleaner when you are tired, distracted or under the influence of drugs, alcohol or
medication causing diminished control.
24.
WARNING!
Do
NOT
use this vacuum cleaner to vacuum lead paint debris because this
may disperse fine lead particles into the air. This vacuum cleaner is not intended for use
under EPA Regulation 40 CFR Part 745 for lead paint material cleanup.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARNING
– DO NOT LEAVE VACUUM UNATTENDED WHEN IT IS PLUGGED IN AND/OR OPERATING. UNPLUG UNIT WHEN NOT IN USE.
Volts
Total length of cord in feet
120V
Ampere Rating
More Not More
Than Than
0
- 6
6
- 10
10 - 12
12 - 16
25
50
100
150
AWG
18
18
16
14
16
16
16
12
16
14
14
14
12
12
Not recommended
4. Insert machine hose end into inlet of tank. Twist slightly to
tighten the connection
(Figure A)
.
5. Attach the extension wands to the accessory end of the
hose. Twist slightly to tighten the connection
(Figure A)
.
6. Attach one of the cleaning accessories (depending on your
cleaning requirements) to the extension wands. Twist slightly to
tighten the connection
(Figure A)
.
7. Plug the cord into the wall outlet. Your cleaner is ready for
use.
I = ON, O = OFF
A
