Shop fox W1871, Owner'S Manual

Page: 15 / 32

-13-
Model W1871 (For Machines Mfd. Since 05/19)
SE
TU
P
Assembly
2 AAA
Batteries
LED Light
Housing
Carriage Bolt
Safety Shield
Round Knob
Battery
Cover
Figure.9. LED light housing and safety
shield components.
Before beginning the assembly process, refer to Items.
Needed.for.Setup
and gather everything you need.
Ensure all parts have been properly cleaned of any
heavy-duty rust-preventative applied at the factory (if
applicable). Be sure to complete all steps in the assembly
procedure prior to performing the
Test.Run.
or connecting
the machine to power.
The Model W1871 comes mostly assembled from the
factory. Using the hardware from the Inventory list on
Page 11, complete the assembly by attaching the LED
light housings, safety shields, and tool rests.
To.assemble.machine,.do.these.steps:
1. Remove battery cover from each LED light housing
and install (2) AAA batteries in each (see
Figure 9
).
2. Attach (1) safety shield to each LED light housing
using (1) pre-attached M5-.8 x 55 carriage bolt and
(1) M5-.8 round knob (see
Figure.9).
3. Attach each assembled LED light housing/
safety shield to top of wheel guard with (2)
M5-.8 x 10 Phillips head screws with captive
washers (see Figure 10 ).
Figure.10. LED light housings and safety
shields attached to wheel guards.
x 2
Wheel
Guards
4.
Attach each tool rest to bottom of wheel guard using
(1) M6-1 x 12 carriage bolt, (1) 6mm flat washer, and
(1) M6-1 6-lobe knob, as shown in
Figure.11
.
Figure.11.
Attaching right tool rest to
wheel guard.
6-Lobe
Knob
Tool
Rest
Wheel
Guard