Shop fox SHOP FOX M1013, Owner'S Manual

Page: 16 / 48

-14-
D('(*Fne\ijDXelXcD]^%J`eZ\-&'0
J<
K
L
G
J_`gg`e^JkiXgI\dfmXc
Jkfg8[aljkd\ek
To ensure that your bandsaw arrives without damage to
the hinge system, a shipping strap was installed. After
removing the shipping strap, you will have to make a
series of adjustments, beginning with the feed stop bolt.
Kfi\dfm\k_\j_`gg`e^jkiXgXe[X[aljkk_\]\\[jkfg
Yfck#[fk_\j\jk\gj1
(% Remove the shipping strap hex bolt and strap with a
12mm wrench, as shown in
=`^li\0
.
Efk\1 B\\gk_`jj_`gg`e^jkiXg`ek_\\m\ekk_Xkpfl
dljkkiXejgfikfij_`gk_\YXe[jXn%
)% Adjust the feed stop bolt and jam nut with a 14mm
wrench ( =`^li\(' ), so the bandsaw blade teeth
are just below the table surface when the cut is
complete.
=`^li\0% Removing shipping strap.
Shipping Brace
=`^li\('% Feed stop bolt.
Feed Stop
Bolt
JhlXi`e^M`j\kf9cX[\
To ensure that your bandsaw will make cuts that match
the degree scale, you must make sure to square the vise
to the blade.
KfjhlXi\k_\m`j\kfk_\YcX[\#[fk_\j\jk\gj1
(% Rotate the headstock until the pointer reads "0" on
the tabletop scale, and tighten the headstock lock
lever so the headstock stays indexed at zero.
)% Using a 6mm wrench, loosen the two cap screws that
hold the vise to the table, as shown in
=`^li\((
.
*% Using a small machinists square, adjust the vise so it
is square to the blade.
+% Tighten the two cap screws, so the vise and blade
are square with one another.
=`^li\((% Squaring vise to blade,
headstock, and table scale.
Headstock
Lock
Lever