COPYRIGHT © AUGUST, 2017 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Printed in China
#19127JH
Model D4648
Cabinet Maker's Front Vise
Instruction Sheet
Phone #: (360) 734-3482 • Online Tech Support: [email protected] • Web: www.shopfox.biz
Specifications
Model
Jaw
Width
Workbench
Thickness
Max. Jaw
Opening
Weight
D4648
13"
1
1
⁄
2
"
5
7
⁄
8
"
13 lbs.
Introduction
Your new Front Vise (see
Figure 1
) is designed to fit on
workbenches 1
1
⁄
2
" thick. The front vise features a solid
hardwood clamping jaw pad.
1.
With help from an assistant, hold front vise up
against workbench in desired mounting location.
Note:
If your workbench has holes for bench dogs,
ensure bench dog holes on top of vise jaw
(see
Figure 1
and
Figure
4 on Page 2)
align with those
holes.
2.
Use a pencil to mark underside of workbench
through six vise mounting holes (see
Figure 2
) to
drill pilot holes in workbench.
3.
Use a
1
⁄
8
" drill bit to drill pilot holes approximately
1" deep in underside of workbench (see
Figure 3).
4.
Attach vise assembly to workbench using (4) #10 x
1
1
⁄
2
" wood screws through underside of workbench,
as shown in
Figure 3
.
Installation
The Cabinet Maker's Front Vise comes fully assembled
from the factory. Mounting hardware is not provided with
this front vise.
Figure 1.
Model D4648 front vise.
Bench Dog Holes
Figure 2.
Mounting hole locations (viewed
from below).
Mounting Holes
Vise
Wood
Screws
Workbench
Figure 3.
Mounting diagram.
