Antenna Installation
4
Install the back
support mounts
a. Pair up the feedline sections and the radiator assemblies, using the bay
number stenciled on each piece.
Important
This back support mount is NOT used with XXL radomes!
b. Attach the back support mount to the feedline:
(1) Lay a feedline section horizontally, supported off the ground, with its
baymount flange pointing downward.
(2) Study your installation drawing. There is a detail identifying the correct
azimuth rotation of the antenna bays from the tower mounting surface.
(3) Now look at the feedline, with its upper and lower mount flanges. The
upper feedline mount flange has a series of notches cut into it (
Figure
1
). The center notch is exactly opposite the baymount flange. Each
notch represents five degrees (5°) of azimuth rotation. Align the
centered mark on the back support mount to the notch representing the
azimuth rotation identified on the installation drawing.
Figure 1. Attach the back
support mount
