Shiro SD8101, User Manual

Page: 22 / 27

U
U
s
s
e
e
r
r
M
M
a
a
n
n
u
u
a
a
l
l
21
Resetting the system
If you have set a PIN and forgotten it, you need to reset the system. The PIN
will be reset to 0000. If you reset the system, you will lose all stored
information (including numbers in memory) and all features will return to
their default settings.
While you are resetting the system, you should disconnect the telephone
line cord from the back of the base unit, so you won't be interrupted by
incoming calls. To reset the system without the PIN:
1. Disconnect the power lead from the back of the base unit
2. Press and hold the HANDSET LOCATOR button in the base unit
3. Connect the power lead into the back of the base unit. After you hear
"beep" sound for five times, then release the LOCATOR button
4. You will hear confirmation tone from the base unit.
Handset registration
Your SD8101 is supplied with the handset already registered to the base unit,
and you shouldn't need to register it. But if you've bought extra handsets
separately, you'll need to register each one to your original base unit.
Maximum 4 handsets can be registered to one base.
To register a handset
1. Press and hold the Handset locator button on the base unit for a
while, until you hear "beep" sound twice continuously.
2. Press the MENU button, then press UP/DOWN button to the
location REGISTER.
3. Press the PHONEBOOK button, then press UP/DOWN button
to the location SUB BASE.
4. Press the PHONEBOOK button again
The display shows BASE? 1 2 3 4
5. Key in a base unit number
The display shows selected number. After a while, when
the handset finds the base unit, the display shows PIN.
6. Key in your pin (default 0000) and press PHONEBOOK to confirm
If the display says NOT REG , check to see if you key in the correct PIN,
then repeat the registration procedure again from step 1.