POWER
Audio Volume
IR
IR
SB-8804MRM
8x8 AUDIO MATRIX SWITCHER
1
2
3
4
5
6
7
8
VIDEO INPUT STATUS
DESTINATION
SOURCE
1
1
1
1
2
2
2
2
3
3
3
3
4
4
4
4
5
5
5
5
6
6
6
6
7
7
7
7
8
8
8
8
DESTINATION
LINK
ST
5
6
7
8
SELECT
1
2
3
4
LOCK
RGB
DESTINATION
SOURCE
PAGE 4
SB-8804 INSTRUCTION & OPERATION MANUAL
FRONT PANEL
FRONT PANEL
3
6
POWER ON SWITCH
SOURCE SELECT BUTTONS
1
The power switch turns the unit on and off.
The LED will illuminate red to indicate
that the switcher is ON and is receiving power
DESTINATION SELECT BUTTONS
3
Depressing this button completes the routing
selection assigned to the particular destination.
Depressing this button selects the source assigned
to the specific channel.
4
LINK
5
Function by optional.
SOURCES SETUP BUTTONS
7
Setup the input sources 1 ~ 8 channel
1
13
4
19 INCH EAR MOUNT PAIR
19 inch 1U(1D) high case Ear Mount pair
Part number : 1U-440L
5
2
9
8
INPUT SOURCES STATUS
2
The 1 to 8 source status show from LED display red
to indicate that a audio source is present on that input.
ST
The switcher automatically set to standby mode
after remove all inputs five minutes.
9
AUDIO CHANNEL SELECT BUTTONS
Press the <SELECT> push button to select the audio
channels in before range the audio volume.
AUDIO VOLUME
Total ten LED display to indicate the audio volume.
To configure a matrix, depress the Source Button under the channel number of the source you desire. Then depress the Destination
Button above the channel number you want to assign the source to. You can depress as many destinations as you desire provided
you do it within x seconds of depress the Source Button.
For example, to assign Source 2 to Destination 3,5,and 6 you would:
Depress Destination 3,5,6
Depress Source 2
That
’
s it.
After 5 seconds, the Source button depress will time out and you can no longer assign it to a destination without depressing it again.
You can however, select Source/Destination assignments back to back without waiting. For example, you can assign Source 3 to
Destination 5,6 immediately followed by Source 4 to Destination 1,2.
OPERATION THE UNIT
Once you have connected your devices to the SB-8804 and energized the chassis, the SOURCE DEVICE STATUS LED DISPLAY
will eliminate indicating that a valid video signal is connected.
7
10
12
IR SENSOR
The IR sensor receives IR commands from the
supplied remote controller.
6
11
RGB
8
LOCK
The front panel push buttons will be lock after you
press <LOCK> keep two seconds, press two
seconds again to remove.
10
Function by optional.
11
12
13
