REMOTE CONTROL
Before making any connections to the SB-5588. Observe the following:
> Ensure the mains voltage supply matches the label on the
supplied plug- Pack (+/- 10%)
> Ensure that the power switch is OFF
> Ensure that all system grounds (earth) are connected to a
common point.
> Avoid powering equipment within a system from multiple
power sources that may be separated by large distances
> Connect all audio video sources and destination equipment
> Power up all source and destination audio-visual sources
> For each destination output select the appropriate input source
by using the front panel input 1~8 select buttons. The
supplied IR remote control. Or through the RS-232 serial
communications port.
> Upon power up the switcher will return to its last used setting
before Powered down.
REMOTE
CONTROL
IR REMOTE CONTROL KEY :
1 2
SWITCH 1 POWER ON or OFF
Controller with a separate power ON and OFF
3
OUTPUT 1~8 DISPLAYS SELECTION
Output -1 : TV-1 Component Video (YPBPR) HDTV Display
Output -2 : TV-2 Component Video (YPBPR) HDTV Display
Output -3 : TV-3 Component Video (YPBPR) HDTV Display
Output -4 : TV-4 Component Video (YPBPR) HDTV Display
Output -5 : TV-5 Component Video (YPBPR) HDTV Display
Output -6 : TV-6 Component Video (YPBPR) HDTV Display
Output -7 : TV-7 Component Video (YPBPR) HDTV Display
Output -8 : TV-8 Component Video (YPBPR) HDTV Display
4
INPUT 1~8 SOURCES SETUP
Input -1 : AV-1 Component Video (YPBPR) Signal source device
Input -2 : AV-2 Component Video (YPBPR) Signal source device
Input -3 : AV-3 Component Video (YPBPR) Signal source device
Input -4 : AV-4 Component Video (YPBPR) Signal source device
Input -5 : AV-5 Component Video (YPBPR) Signal source device
Input -6 : AV-6 Component Video (YPBPR) Signal source device
Input -7 : AV-7 Component Video (YPBPR) Signal source device
Input -8 : AV-8 Component Video (YPBPR) Signal source device
7