BACK PANEL
BACK PANEL
CONNECTING THE HARDWARE
Please study the panel drawings below and become familiar with the signal input-output, Power requirements plus any controls present.
Before using the switcher, please take the time to make certain that the device you wish to connect to its inputs is functioning properly in
all respects. Verify that the video and audio signals are present and are being displayed properly on a suitable device.
If all is well connect the appropriate cables between the output of the device you wish to distribute to output(s) of the switcher to the
carious devices you wish to feed a signal to.
Lastly, connect the AC to DC adaptor, connect the DC connector to the switcher fi rst and then plug the adaptor into a functional AC outlet.
6
1. DC POWER INLET:
The Switcher is fi tted with a DC power plug-park input connector.
Please ensure that the plug-park used is of an approved type and
is of suffi cient current carrying capacity with the correct voltage
and connector polarity. 12Volt DC power supply 1.25A Max.
2. IR EXTENDER CONTROL
Support one of IR Extender (IR input)
Extend distance maximum 300 M
3. RS-232 CONNECTION:
RS-232 control port to allow for interfacing to a PC, such as a
computer or touch panel control, to the switcher via this DB-9pin
Female connector for serial RS-232 control.
4. INPUTS: 1-4 VGA SOURCE PORTS:
Connect a signal source of VGA (RGBHV) devise via VGA cable
output to 4x VGA Monitor displays.
5. OUTPUTS: 1-4 VGA RGBHV PORTS:
Connect a signal of VGA via VGA cable output to VGA Monitor
displays from 4x VGA input source devices
Power Jack:
DC Jack - Inner OD Ø 2.1 mm (+)
Outside OD Ø 5.5mm (GND)
Power input -12VDC, 1.25A
IR Extender Jack:
Female Jack - inner OD Ø 3.5 mm
Remote Port:
DB-9pin Female connector
VGA (RGBHV) Via 1x HD-15p connector
Note: With 1x female D-Sub connector.
VGA (RGBHV) Via 1x HD-15p connector
Note: With 1x female D-Sub connector.