Shining 3D Transcan-C_User Manual_V1.4.2
57
9.
FAQ
1.
What if no scan data when the turntable has rotated one circle?
Solution: Please make sure that the object won’t block the mark points on the turntable. Or there will
be no fringe pattern, while turntable will be still rotating. If the align mode is mark point, please make
sure that the marks on the turntable are covered, so as not to affect the scanning. Make sure that in
each single scan area has at least 4 points.
2.
What if the alignment fails without markers when the turntable has rotated several circles?
Solution: Try to make sure there are at least 1/3 overlap between the current scan area and the
previous scan area and the object surface should be featured. For objects which are symmetric and
without rich features, using mark points or manual merger is recommended.
3.
How to scan objects in transparent, semi-transparent or black?
Solution: Scan after spraying on the surface.
4.
If the turntable is not moving, but with a humming sound, how to solve?
Solution: Disconnect power line and connect again in few seconds.
