Feed control knob/wire through
4.
the T-handle until spring touches
the round hole. CAUTION: Do Not
Compress Spring At This Time. Feed
wire through the square handle tube.
Be sure wire passes above the bolts
in the handle brace. Secure T-handle
to the tube with 1/4-20 x 2 1/4” hex
bolts, washers, and hex nuts as
shown. Remove caution label and
push the thumb release toward the
center and push down knob and
shutoff spring until knob latches.
CAUTION: Once knob is latched, do
not move thumb release until you have
completed in step #5.
Slide wire retaining clip onto
5.
wire as shown. Insert wire
through hole shutoff plate. Slide
wire retaining clip over shutoff
plate and wire until the clip locks
into place.
Install handle grips onto the
6.
handle as shown. Soapy
water will ease installation.
(Do not use petroleum
based products). Insert
screen into hopper by sliding
it under the screen clips.
Remove Caution
Label
Control Knob &
Wire Assembly
Thumb
Release
Spring
1/4-20
x
2 1/4”
Bolt &
Washer
1/4-20 Hex Nut
& Washer
Wire Clip
Wire
Shutoff Plate
Handle Grips
Screen
Screen
Clips
