Shindaiwa EB508RT, Owner'S/Operator'S Manual

Page: 13 / 28

13
sTarTIng warm engIne
The starting procedure is the same as Cold Start except DO NOT close
the choke.
1.
Throttle Position / Stop Switch Button
Slide Throttle position / Stop switch Button(A) back to idle posi-
tion.
2. Purge Bulb
Pump purge bulb (D) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
3. Recoil Starter
Pull recoil starter handle (E) and engine should start. Do not use
choke (C).
NOTE
If engine does not start after 5 pulls, use cold start procedures.
sToppIng engIne
1. Throttle Position / Stop Switch Button
Release throttle trigger. Move Throttle Position / Stop Switch
Button (A) forward to idle position and allow engine to return to
idle before shutting off engine.
2.
Throttle Position / Stop Switch Button
Move Throttle Position / Stop Switch Button (A) all the way
forward to STOP position.
WARNING
If engine does not stop when stop switch is moved to STOP posi-
tion:
• Be certain engine is at idle, otherwise engine may continue to run.
• Close choke - COLD START position - to stall engine.
• Have your Shindaiwa dealer repair stop switch before using
blower again.
A
A
e
C
D