AH262
MAINTENANCE
X7502342300
33
© 6/2017 ECHO Inc.
ENGLISH
Note: Every unit is run at the
factory and the carburetor
is set in compliance with
emission regulations.
Carburetor adjustments,
other than idle speed,
must be performed by an
authorized dealer.
1.
Check idle speed and reset if
necessary. If a tachometer is
available, idle speed screw (A)
should be set to the
specifications found on
“Specifications” page of this
manual. Turn idle screw (A)
clockwise to increase idle
speed; counterclockwise to decrease idle speed.
Lubrication
Blades
Level 1.
Hedge Trimmer blades are very sharp. Touching them may lead
to severe personal injury. Avoid touching blades whenever
possible, and always wear gloves to protect hands.
1.
Brush loose debris from blade
and coat both sides of blade
with the 50-50 cleaning mixture.
2.
Allow cleaning mixture to soften
the remaining gummy residue
then wipe it from the blade.
3.
Apply clean oil to the entire
length of the blade. Be certain
the blade bolts are lubricated.
4.
Wipe excess oil from the blade
before putting the unit back in
service.
Parts Required:
20W Engine Oil (blade lubrication), 50-50 mixture of
kerosene and 20W oil (blade cleaning)
A
A