8
Prior to each work day, perform the
following:
Check for loose or missing screws or
■
components. Make sure the cutting
attachment is clean, free of debris
and securely fastened.
Check the entire machine for leaking
■
fuel or grease.
Make sure that nuts, bolts, and
■
screws (except carburetor adjusting
screws) are tight.
WARNING!
Non-standard parts may not oper-
ate properly with your unit and may
cause damage and lead to personal
injury.
IMPORTANT
Using non-standard replacement
parts could invalidate your Shindaiwa
warranty.
WARNING!
Before performing any maintenance,
repair, or cleaning work on the unit,
make sure the engine and cutting
attachment are completely stopped.
Disconnect the spark plug wire
before performing service or mainte-
nance work.
IMPORTANT!
For detailed maintenance information
about your Multipurpose Tool Carrier,
consult the owner’s manual that was
provided with it. If it has been lost or
misplaced, contact Shindaiwa for a
replacement.
Maintenance
Using a Hand-Held Edger
CAUTION!
Low-speed edging can lead to pre-
mature clutch failure.
Guidelines for Operating the
Edger
Before edging, make sure the area
■
is soft enough so the blade does not
bog down. If necessary, water the
area before edging.
Remove debris and other obstacles
■
that could be thrown by the rotating
blade.
Plan your work so the edger blade
■
is always on your right-hand side.
Begin each pass by positioning the
■
unit over the work, and with the
engine running at about half-throttle.
Slowly lower the blade to the ground
while applying full throttle.
Do not move the edger into the work
■
so fast that the engine or blade bogs
down.
Regular and frequent use of the edger
will make a neater lawn, and a fre-
quently trimmed edge will be easier to
maintain.
Figure 10
65010-94010_MLE230_07LP
11/21/01, 11:19 AM
13
WARNING!
Wear eye protection, long pants,
■
and boots when operating this
machine!
Whenever you strike a hardo
■
bject with the blade, always stop
the edger and carefully inspect
the blade for damage. NEVER
OPERATE THE EDGER WITH A
DAMAGED BLADE!
Summary of Contents for 65010
Page 11: ...11...
