Shindaiwa 358Ts, Operator'S Manual, Page: 10 / 34

10 358Ts
WARNING
Saw chain is sharp! Always wear gloves
when handling assembly, otherwise serious
personal injury may result.
INSTRUCTIONS TO INSTALL
OPTIONAL KICK GUARD
TM
TO
BAR
Tools Needed: Two 3/8 in. Wrenches.
1. Install 8-32 bolt in
small
hole of Kick Guard
TM
and through
small
hole in guide bar.
2.
IMPORTANT:
Dimple in Kick Guard
TM
(A)
must
engage recess in guide bar (B).
3. Tighten nut (C) and bolt by hand until snug.
Make certain Kick Guard
TM
is flush against
guide bar.
4. Tighten nut additional 1/2 turn.
5. Check to make certain Kick Guard
TM
is tight on
guide bar.
GUIDE BAR AND SAW CHAIN
INSTALLATION/REMOVAL
NOTICE
• Move the chain brake lever (Front hand guard)
fully rearward to remove or install the clutch
cover to chain saw.
• Align the brake connector of the clutch cover to
the groove on the side of the brake lever (Front
hand guard).
1. Remove spark plug lead. (See page 26)
2. Remove the clutch cover nuts and remove clutch
cover.
3. Remove bar and saw chain if necessary. See
“Maintenance and Care” section for guide bar /
saw chain maintenance procedures.
PREPARATION FOR USE
Clutch cover
Brake lever
(Front hand guard)
Two nuts
Brake connector