Page: 12/15
Remote control storage area
Remote control
Figure 13 Figure 14
3). For cleaning, put the evaporator filter frame, condenser filter frame, evaporator filter mesh,
and condenser filter mesh into warm water (about 40
℃
) mixed with a neutral cleaner,
and then dry them in the shade (as shown in Figure 15).
Note: 1. Take care to not damage the mesh fabric on the filter frame and filter mesh.
Figure 15
2.2 Installation of the filter frame and filter mesh
Special note: be sure to install the filter mesh first and then install the filter frame.
1
）
To install the evaporator filter mesh and condenser filter mesh, point the back end of the filter
mesh toward the socket and then push the filter mesh evenly and gently into the socket.
Note: 1. Install the filter mesh in the reverse order of removal. The filter mesh must be
installed into place; otherwise, the filter frame may not be installed into place.
2. Install the filter mesh gently so as not to damage it.
2). To install the evaporator filter frame and condenser filter frame, point the back end of the
filter frame toward the socket and then push the filter frame evenly and gently into the
socket.
Note: 1. Install the filter frame in the reverse order of removal. Be sure to install the filter
mesh first before the filter frame is installed.
2. Install the filter frame gently so as not to damage it
3.
Cleaning of the handle position and remote control storage area
1). Take the remote control out of the remote control storage area in the direction shown by
the arrow; (as shown in Figure 16)
Figure 16
2). Clean the handle position and remote control storage area with a damp soft cloth;
Note: the soft cloth must be damp, not wet. Do not drip water into the unit.
3). If the remote control needs to be put back into the remote control storage area, put it back
into the storage area in the reverse direction of removal.
