Shihlin electric SL3 Series, User Manual

Page: 60 / 211

System parameter group 00
PARAMETER DESCRIPTION 58
5.1.12 50/60Hz switch selection

Select between 50Hz or 60Hz according to different power source frequency or default motor frequency, this
effects all frequency-related parameters.
Parameter Name Default Setting Range Content
00-24
P.189 50Hz/60Hz switch
selection
0 0
Frequency related parameter default value is 60Hz.
1 1
Frequency related parameter default value is 50Hz.
50/60Hz switch selection

The following two steps shows how to set frequency related parameter to 60Hz system (00-24(P.189)=”0”).
1. Set 00-24(P.189)=0;
2. Set 00-02=3(P.998=1) to set all parameters to default, at this point frequency-related parameters of the inverter will be
reset to 60Hz.

The following parameters are affected:
Group No. Name Group No. Name
01-03 P.3 Base frequency 05-04 P.305 Motor rated frequency
01-09 P.20 Acceleration/deceleration reference
frequency 05-06 P.307 Motor rated rotation speed
02-21 P.39 Maximum operation frequency
（Terminal 3-5input signal/ built-in
keypad knob set frequency） 06-03 P.66 Stall prevention operation reduction
starting frequency
08-14 P.182 Upper integral limit
5.1.13 Parameter mode setting

Select “Sequence P mode” or “group mode” to display parameters.
Parameter Name Default Setting Range Content
00-25
P.990 Parameter display
mode setting
0
0
Parameter is displayed in “group mode”
1
Parameter is displayed in “sequence P mode”
Parameter mode setting
 “Group mode” displaying

“Sequence P mode” displaying
Setting
Display