Shihlin electric SL3 Series, User Manual

Page: 52 / 211

System parameter group 00
PARAMETER DESCRIPTION 50
5.1.4 Monitoring function

Item to monitor on built-in keypad can be selected.
Parameter Name Default Setting Range Content
00-06
P.110 Built-in keypad
monitor selection
2
0
When inverter starts, built-in keypad enters monitor mode
automatically, screen displays output frequency (Note 1 ).
1
When inverter starts, built-in keypad displays target
frequency.
2
When inverter starts, built-in keypad enters monitor mode
automatically, screen displays steady state output frequency
3
When inverter starts, built-in keypad enters monitor mode
automatically, screen displays current pressure and feedback
pressure of the constant pressure system in percentage
4
When inverter starts, built-in keypad doesn’t enter monitor
mode but enter the previous mode before power off
5
When inverter starts, built-in keypad enters monitor mode
automatically, screen displays current pressure and feedback
pressure of the constant pressure system
00-07
P.161 Multi-function
display
0
0 Output AC voltage (V)
1 DC bus voltage. (V)
2 Inverter temperature rising accumulation rate (%)
3 Target pressure of the constant pressure system (%)
4 Feedback pressure of the constant pressure system (%)
5 Running frequency (Hz)
6 Electronic thermal accumulation rate (%)
8 Signal value (mA) of 3-5 input terminals (mA/V).
9 Output power (kW).
11
Forward reverse rotation signal. 1: forward rotation 2: reverse
rotation 0: stop.
12 NTC temperature (℃)
13 Motor electronic thermal accumulation rate (%)
14~18 14~18：Reserved
19 Digital terminal input state
20 Digital terminal output state
21 Actual working carrier frequency
Note: 1. The “output frequency” here is the value after slip compensation.
2. The multi-function display function is implemented in the monitor voltage mode. For switching to monitor voltage mode, refer
to section 4.2.3.
3. Digital terminal input state detail
b0
STF STR M0 M1
b1 b2 b3
4.
Digital terminal output state detail