Parameter Description
Parameters
130
and P.95 and P.96 (the third set).
Parameter
Factory setting
Setting range
Remarks
91~96
99999
0~650Hz, 99999
99999: invalid
P.91
P.92 P.93 P.94 P.95 P.96
Output
frequency
(Hz)
<Setting>
• For example: assuming P.91=45 and P.92=50;
If the target frequency
≦
45Hz, then the steady output frequency=the target frequency.
If 45Hz
≦
target frequency
＜
50Hz, then the steady output frequency=45Hz.
If the target frequency
≧
50Hz, then the steady output frequency=the target frequency.
Note: 1. During the acceleration / deceleration period, the output frequency of the inverter will still pass
through the jump frequency.
2. When P.91=99999 or P.92=99999, the first set of frequency jump is invalid.
When P.93=99999 or P.94=99999, the second set of frequency jump is invalid.
When P.95=99999 or P.96=99999, the third set of frequency jump is invalid.
5.45 Programmed Operation Mode (P.100~P.108, P.111~P.118,
P.121~P.123, P.131~P.138)
P.100 “Minute/second selection”
P.101~P.108 “Runtime of each
section”
P.111~P.118 “Acceleration/
deceleration time of each section”
P.121 “Run direction in each section”
P.122 “Cycle selection”
P.123 “Acceleration/deceleration time
setting selection”
P.131~P.138 “Frequency of each
section”
Related parameters
P.80~P.84, P.86,P.126, P.550
“
Multi-function terminals selection
”
P.8
“
Deceleration time
”
P.7
“
Acceleration time
”
P.21
“
Acceleration/deceleration
time increments
”
