Setup Mode
: Available Settings
Upon entering Setup Mode, you need to choose which settings you wish to edit.
All settings are divided into 3 pages accessible via the
BANK
switch. Move the
BANK
switch to the desired position,
as listed below.
●
UP:
Global Setup.
●
CENTER:
MIDI Setup.
●
DOWN
: Expression Pedal Setup.
Some of the parameters (BEAT switch subdivisions and MIDI channel 12-16 setup) can only be edited via the config file.
To edit those settings, you need to access the config file via
.
Global Setup
While in
Setup Mode
, set the
BANK
switch to the UP position.
Parameter settings use dual-function indication: the ON LED displays the CHARACTER and DECAY knob parameters,
while the ALT LED refers to the X-MIX and PDL/TIME knob parameters. If a group’s parameters are disengaged, the
respective LED doesn’t flash.
The
Global Setup
page provides access to the following settings:
●
Global “reverb tails in bypass” setup
is done via the CHARACTER knob:
○
7:00 (fully CCW): No tails in bypass. The ON LED doesn’t flash blue.
○
5:00 (fully CW): Tails present in bypass (default setting). The ON LED flashes blue.
●
Quick Access operation
is set via the DECAY knob:
○
7:00 (fully CCW): The Quick Access function is inactive. The ON LED doesn’t flash green.
○
5:00 (fully CW): The Quick Access function is active (default setting). The ON LED flashes green.
●
GUITAR/LINE level selection
is done via the X-MIX knob:
○
7:00 (fully CCW): Guitar level (default setting). The ALT LED doesn’t flash red.
○
5:00 (fully CW): Line level. The ALT LED flashes red.
●
CTRL input mode
is selected via the PROGRAM knob. Set the PROGRAM knob to the desired position:
○
1: Passive controller
(normally open momentary switch). Footswitch functions are replicated. TIP
corresponds to the TAP/ALT footswitch, RING corresponds to the ON/HOLD footswitch.
○
2: Full MIDI control
(Type A). This mode is active by default.
○
3: S-trigger
(“short circuit trigger”). Analog trigger/gate with the same polarity as the pedal’s. This is the
recommended trigger type. TIP controls the TAP function, RING controls the HOLD function.
○
4: V-trigger
(“voltage trigger”/”positive trigger”). Analog trigger/gate with polarity opposite to the pedal’s. If
no external signal is coming into the CTRL input, the LED will light up, and some of the pedal’s functions will
be inactive. Those functions become active as soon as a control signal is connected. TIP controls the TAP
function, RING controls the HOLD function.
Use this trigger type if you have no S-trigger source or if you
prefer V-triggers for other reasons.
○
5: Passive expression pedal
(TS or TRS, 10-25kOhm). Provides external control over the DECAY knob.
Expression pedals with TS (mono) connection are recommended. More expression pedal functions will be
implemented later.
○
6: Passive controller
(normally open momentary switch) or analog S-trigger. TIP controls the Quick Access
function, RING controls the TAP function.
