ENGLISH
3 1
Using the OSD
CURRENT STATUS DISPLAY
This mode shows the status corresponding to each operation.
The on-screen display will automatically disappear in 5 seconds.
For examples, there are 2 status displays as follows.
When selecting the desired input source. When selecting the TEST TONE mode.
This unit incorporates an OSD(On-screen display) function to provide information about basic operation of this unit and to
simplify the setup procedures.
The OSD function uses a monitor TV connected to this unit as a display and has two kinds of display modes such as current
status display and menu screen.
Notes: When the component video connections are made between the monitor TV and this unit, the OSD function is not
available.
Any on-screen display shown on the monitor TV will not be recorded onto VIDEO 1.
In some countries, this unit allows you to select either NTSC or PAL color system as video format.
If it is different from your video components, video softwares, etc., in the standby mode, press the STANDBY
button while keeping the AUTO/MANUAL button pressed on the front panel, then the video format is changed
to the NTSC or the PAL color system.
However, it is fixed to NTSC color system in other countries.
MENU SCREEN
This function simplifies the setup procedures for items such as the speaker mode, function select, surround mode, delay
time and channel level trim.
The menu screen operation is performed easily with the CURSOR control(
,
,
,
), ON SCREEN DISPLAY and
ENTER buttons.
The “3”, “7”, “8” and “9” of the NUMERIC buttons do also work as cursor control. In this case, the “3” button stands for the
CURSOR UP(
) button, the “7” for the CURSOR LEFT(
), the “8” for the CURSOR DOWN(
) and the “9” for the
CURSOR RIGHT(
).
VIDEO 1 (DIGITAL)
Input source
Signal input
FL ----------------- ------------------- 0
(( ))
FL C FR
SW
RL RR
Channel level or overall volume display
The main menu will be shown.
To turn the menu screen off, press this button again.
In the button of the display, “up” stands for the CURSOR
UP( ) button. “down” for the CURSOR DOWN( ),
“OSD” for the ON-SCREEN DISPLAY and “ENTER” for
the ENTER button.
SE
TUP
AUD
SAT
VOL
VID 4
SE
TUP
P.SCAN
VOL
SLEEP
CH LEVL
HOME THEATER MASTER
RNC-30
PWR
ENTER
PHONO
CD
TUNER TAPE MON
T2 MON
VID SEL
VID 2
VID 3
VID 4
AUX
ROOM 2 SYS DISP
AUD
CD
DVD
AUX
TV
VCR
CBL
SAT
1
2
3
4
5
6
7
8
9
MUTE
0
CH SEL
T.TONE
D.TIME
D.ADJ
STEREO
AUTO
6.1CH IN
C.MODE
DSP MODE
OSD
OSD
MAIN MENU
Main menu display
up/down : MOVE
OSD : END ENTER : SELECT
SPEAKER MODE
FUNCTION SELECT
SURROUND MODE
DELAY TIME
CH LEVEL TRIM
When adjusting each channel level or overall volume, the
volume level display will be shown.
The test tone display will be shown until the test tone mode
is canceled.
Turn the menu screen on.
1
