To AUTO LEARN or program in the remote control
signals to the units memory, simply connect the
two AUTO LEARN terminals together.
Once a signal is learnt in the unit will flash the Rx LED
followed by the Tx LED.
Once all the remotes are programmed, you can disconnect the
wires connected to the AUTO LEARN terminals.
Please note: If the remotes are already handed out, and you
have no way of getting hold of them to program them in, it
will be quite acceptable to leave the unit in AUTO LEARN mode
for a few days or even a week if needed. The unit will work
the same whether it is in LEARN MODE or not.
LEDS explained:
Rx
- one flash means it has received a programmed signal
Tx
- one flash means that the unit is transmitting the signal
1. Remove all jumpers off the PCB.
2. Bridge the Default jumpers to the ON position for
10 seconds. The Rx & Tx LED will flash.
3. Once the unit is successfully defaulted all the LEDs
will turn on & stay on.
4. Remove the bridge from the ON position and wait for
the LEDs to turn off.
5. The unit is now ready to be reprogrammed.
LEARNING THE AC FAIL SIGNAL TO A STANDARD RECEIVER:
Then Bridge the AC Fail
jumpers on the Repeater
unit. The Receiver will
sound two beeps once it
has learnt in the signal.
Press the Learn switch on
the Receiver to take the
unit out of LEARN mode and
back into Normal operation
mode.
Step 3.
LEARN
2 beeps
Long beep
Refer to the relevant Receiver programming procedure. Below is a standard
1 Channel Receivers programing procedure. Model RX1-500
PROGRAMMING THE REPEATER:
DEFAULTING MEMORY:
LEARN
Step 1.
Step 2.
Press the Learn switch on
the Receiver unit
1 beep
Page 6
