Start
Stop
Start
Stop
Start
Stop
!
!
WARNING - DANGER
The remote starter for standard transmission does not monitor the position of the gear shift. It requires the user of
the vehicle equipped with this remote car starter for manual transmission to
set the parking brake
and
leave the
gear shift in neutral position at all time
before leaving the vehicle
even when he does not intend to remote start the
vehicle
. The manufacturer and Sherlock will not be liable for any consequences resulting from misuse, Negligence
or Improper installation
STANDARD TRANSMISSION
Remote car starter
DD900plus
User
Guide
WWW.SHERLOCK.CA
Lock
Arm
Unlock
Disarm
Start
Stop
Option
The following sequence must be performed in order to remotely start a vehicle with standard transmission:
1. While the engine is running (having been started with the key), put the gear shift into Neutral position, and set the
parking brake
2. Press momentarily the button of the transmitter, parking lights will stay on.
3. Remove the key, engine should remain running.
4. Exit the vehicle, close all doors, engine will shut off with 1 chirp (if installed), doors will lock* & alarm* will
engage automatically after 3 seconds.
5.
If after closing the last door, the engine still runs, then press button to shut the engine and have your
system checked by your installer, this is not a normal operation and your remote starter is out of function.
6. As soon as any door is re-opened, the remote starter will be automatically cancelled. To use the transmitter to
remotely start again, repeat steps 1, to 4
*optional
Pit stop mode
Running mode - Without key
(applicable only for automatic transmission )
To keep the engine running & the accessories working (heater, air conditionning) for a short time when you’re not
in the vehicle, proceed as follows:
Before turning the engine off:
1. Press once button
2. Remove the key from the ignition. The engine will keep running.
3. Open and close the door. Arm & lock with the remote (if installed) or with your key. The engine
will keep running for a maximum of 18 minutes.
N.B.: This feature will not work if the brake pedal is depressed.
Unlock
Disarm
Starter kill
(optional)
Car starter will not operate when the starter kill is in function. After disarming, the system will re-arm automati-
caly within 60 seconds except if the car is started within 60 seconds.
To disarm, press once the button
of the transmitter and start the vehicle.
Valet mode / Emergency override
In case of loss or malfunction of the transmitter, use this mode to override the alarm and/or the starter kill func-
tion:
a) turn the key to RUN (
On)
position
b) immediately within 6 sec., press and release the override button ( red button hidden, ask your installer for loca-
tion). You will hear 1 chirp to confirm (if installed) - start as usual. The LED will flash in a 5 seconds duty cycle.
System is temporarily out of use. To reset, repeat step a and b. You will hear 2 chirps to confirm (if installed).
The LED will start flashing every second in normal operation.
Arm / Lock
(optional)
Press button to arm. Parking lights will flash once, horn or siren will chirp once
(if installed)
.
System is armed within 3 seconds. LED
(red flashing light inside vehicle)
starts flashing.
Any attempt to open the doors will immediately trigger the horn for 30 sec. (or siren for 60
sec.). To stop, press the same button once again.
Panic
(optional)
Hold 3 sec. to trigger the horn or siren continuously. To stop, press and release.
Disarm / Unlock
(optional)
Press button to disarm / unlock. Parking lights flash twice with 2 chirps. Alarm system
and/or starter kill function is temporarily disarmed for 60 seconds.
Trunk
(optional)
Hold button for 3 seconds to release the trunk lid. Parking lights will flash 3 times. Alarm
system is disarmed automatically.
Start / Stop
Press button to start. Parking lights will flash 6 times
and stay on for the duration of the cycle (12 or 18 min-
utes). Press again to stop.
Panic
(red button)
Press 1 sec. to arm and lock
Hold for 3 sec. to activate the panic mode. To stop,
Press and release momentarily.
Press button 1 sec. to lock and/or arm with silent
mode. Use same button to disarm and/or unlock.
Lock
Arm
Unlock
Disarm
Flashing LED
(flashing red light located inside the vehicle, optional)
The LED stays on for one minute to monitor the engine signal after the engine has been started with
the key.
If it’s not the case, please get your system for inspection.
When the alarm or the starter
kill is in operation, the LED will flash regularly every second.
When the system is in valet mode, the LED stays on for 5 sec. and then off for another 5 sec. alterna-
tively.
Security switch (ON/OFF)
(ask for it’s location)
Leave the security switch to the OFF position to disable the operation of the remote starter (such as
when indoor parking or for car maintenance, etc...). Switch back to ON position for normal operation.
Cold start timer every 2 hours
for 6 minutes (night timer)
Press +
together to enable this function, parking lights will flash twice
to confirm. To cancel this feature, start the vehicle with the transmitter or with the key.
Contact list
Sherlock Antitheft Marking inc.
, 440 Ste-Hélène st., Longueuil, Qc., J4K 3R2, 514-861-2761
Web site: WWW.SHERLOCK.CA, Email: [email protected]
Support : Day:1-800-361-0711, Evening and Week end: 514-894-2384
Thank you for your purchase of a Sherlock
remote starter.
Please read your guide carefully to get the
maximum benefits of your system.
