Starter kill
(optional)
Car starter will not operate when the starter kill is in function. After disarming, the system will re-arm automati-
caly within 60 seconds except if the car is started within 60 seconds.
To disarm, press once the button
of the transmitter and start the vehicle.
Valet mode / Emergency override
In case of loss or malfunction of the transmitter, use this mode to override the alarm and/or the starter kill func-
tion:
a) turn the key to RUN (
On)
position
b) immediately within 6 sec., press and release the override button ( red button hidden, ask your installer for loca-
tion). You will hear 1 chirp to confirm (if installed) - start as usual. The LED will flash in a 5 seconds duty cycle.
System is temporarily out of use. To reset, repeat step a and b. You will hear 2 chirps to confirm (if installed).
The LED will start flashing every second in normal operation.
Pit stop mode
Running mode - Without key
To keep the engine running & the accessories working (heater, air conditionning) for a short time when you’re not
in the vehicle, proceed as follows:
Before turning the engine off:
1. Press once button
2. Remove the key from the ignition. The engine will keep running.
3. Open and close the door. Arm & lock with the remote (if installed) or with your key. The engine
will keep running for a maximum of 18 minutes.
N.B.: This feature will not work if the brake pedal is depressed.
Flashing LED
(flashing red light located inside the vehicle, optional)
The LED stays on for one minute to monitor the engine signal after the engine has been started with
the key.
If it’s not the case, please get your system for inspection.
When starter kill is in operation,
the LED will flash regularly every second.
When the system is in valet mode, the LED stays on for 5 sec. and then off for another 5 sec. alterna-
tively.
Security switch (ON/OFF)
(ask for it’s location)
Leave the security switch to the OFF position to disable the operation of the remote starter (such as
when indoor parking or for car maintenance, etc...). Switch back to ON position for normal operation.
Cold start timer every 2 hours
for 5 minutes (night timer)
Press +
together to enable this function, parking lights will flash twice
to confirm. To cancel this feature, start the vehicle with the transmitter or with the key.
Remote car starter
DD700plus
User
Guide
WWW.SHERLOCK.CA
Arm / Lock
(optional)
Press button to arm. Parking lights will flash once, horn will chirp once
(if installed)
. System
is armed within 3 seconds. LED
(red flashing light inside vehicle)
starts flashing.
Panic
(optional)
Hold 3 sec. to trigger the horn or siren continuously. To stop, press and release.
Disarm / Unlock
(optional)
Press button to disarm / unlock. Parking lights flash twice with 2 chirps. Starter kill function
is temporarily disarmed for 60 seconds.
Trunk
(optional)
Hold button for 3 seconds to release the trunk lid. Parking lights will flash 3 times.
Start / Stop
Press button to start. Parking lights will
flash 6 times and stay on for the duration
of the cycle (12 or 20 minutes). Press
again to stop.
Press button 1 sec. to lock and/or arm
with silent mode. Use same button to dis-
arm and/or unlock.
Contact list
Sherlock Antitheft Marking inc.
, 440 Ste-Hélène st., Longueuil, Qc., J4K 3R2, 514-861-2761
Web site: WWW.SHERLOCK.CA, Email: [email protected]
Support : Day:1-800-361-0711, Evening and Week end: 514-894-2384
Thank you for your purchase of a Sherlock
remote starter.
Please read your guide carefully to get the
maximum benefits of your system.
