SW8021 LoRaWAN Gateway Module Datasheet V1.0.0
Shenzhen Seener Wireless Technology Co., Ltd
- 5 -
3.2.2
Power pins
SW8021 series modules has multiple power and ground pins available on the mPCIe connector.
It is recommended that all power and ground pins be used when connecting to the module.
3.2.3
RF connection
The modules have one RF interfaces over standard UFL connector (Hirose U. FL-R- SMT) with the characteristic
impedance of 50
Ω
.
3.2.4
RESET pin
SW8021 series modules card includes the RESET active-high input signal to reset the radio operations as specified
by the SX1302 Specification.
3.2.5 GPS_PPS
SW8021 card includes the GPS_PPS input for received packets time-stamped.
3.2.6 I2C Interface
SW8021 integrates STTS series temperature sensor, which is connected by I2C interface. The PIN on the golden
finger provides I2C connection, allowing I2C to directly connect to the sensor, and obtain the temperature
information detected by the current module sensor
4.
Reliability Test and Approves
Tests for product family qualifications are according to ISO 16750 "Road vehicles
–
Environmental conditions and
testing for electrical and electronic equipment
”
, and appropriate standards.
Products marked with this lead-free symbol on the product label comply with the "Directive
2002/95/EC and Directive 2011/65/EU of the European Parliament and the Council on the
Restriction of Use of certain Hazardous Substances in Electrical and Electronic Equipment" (RoHS).
All Naviecare SW8021 modules are RoHS compliant.
FCC Caution
:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
