SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD
Http://www.carymart.com E-Mail: [email protected]
Setting different control modes:
Setting control mode Momentary: Connect Jumper 1&2
Press and hold button
▲
on the transmitter: motor rotates in positive direction. Release button
▲
on the transmitter: motor stops.
Press and hold button
▼
on the transmitter: motor rotates in reversal direction. Release button
▼
on the transmitter: motor stops.
Limit control terminals:
Limit control terminals TOPR, COM and TOPL are normally close, you can connect limit switches or sensors (normally close type) to TOPR, COM
and TOPL, and then you can use limit switches or sensors to stop the motor.
When motor rotates in positive direction, if disconnect two terminals TOPR & COM, the motor will stop automatically.
When motor rotates reversal direction, if disconnect two terminals TOPL & COM, the motor will stop automatically.
Wired control terminals:
You can connect manual switches to terminals
“COM”, “UP”, “Signal DOWN”, then you can use manual switches to control the motor.
When connect terminals
“UP” and “COM”, motor rotates in positive direction. And when disconnect “UP” and “COM”, motor stops.
When connect terminals
“DOWN” and “COM”, motor rotates in reversal direction. And when disconnect “DOWN” and “COM”, motor stops.
How to pair the transmitter to the receiver:
1) Press the learning button of receiver for 1- 2 seconds; signal LED on the receiver is on. The receiver enters into status of LEARNING.
2)Press and hold button
▲
on remote control, signal LED flashes 2 times, release button
▲
; then press and hold button
▼
on remote control,
signal LED flashes 2 times again, release button
▼
, signal LED is on; it means learning is successful. press the learning button of receiver, signal
LED turns off, or
restart the receiver.
3) When receiver is in the status of LEARNING, press again the button of receiver, signal LED turns off, learning process will be discontinued.
4) The receiver can learn several remote controls with different codes.
Delete all transmitters:
We have learned remote control to
the receiver. If you don’t want the receiver to work with the remote control, you can delete all codes of remote
controls, which are stored in the receiver.
Operation: Press and hold the button of receiver until signal LED flashes 3 times then off; release the button. That means all stored codes have been
deleted successfully.