Version:204800171026
Base dimensions of 90mm
×
90mm
×
6.5mm (Length
×
width
×
height), mounting hole diameter
Ø
5mm, fixing hole spacing is 60mm ~ 62.5mm, line pipe from the base lower penetration into the line
shown in Figure 3.
Fig.2
Fig. 3
Base
V. Wiring and Connections
According to the wiring diagram, connect the wires to the desired end. Figure 4 shows,t is proper to use
RVS twisted pairs with a section of area of equal to or larger than 1.0mm
2
for the signal buses L1 and L2.
VI. Use
Address coding:
The address of the
A9060T
, you can hand-held encoder (CODER-9001) programming,
the encoder must be purchased separately. The output of the encoder plug into the socket on the
A9060T (see Figure 4 Encoder Interface), set the coder with the coding function, compile the correct
address code and press the RUN key to complete the address code setup. Note: See the User
’
s Manual
of the coder for detailed operation.
Start:
When there is a fire manual confirmation, press the pressing sheet on the panel of A9060T (see
Fig.5). After the manual fire alarm is given, the ALARM indicator will remain lit.
Reset:
The special tool into the manual reset button on the side of the hole being depressed can make
restitution by piece. Reset the fire alarm control system and restore the A9060T to the normal monitoring
status.
VII. Precautions
1.A manual fire call points cannot share an address with other equipment in a single bus circuit, or else
an address conflict may occur.
Fig. 4
Fig.
5
----------------------------------------------------------------------------------------------------------------------------
Address
：
3F, Guangcai Xintiandi Mansion, Nanshan Road, Nanshan District, Shenzhen, Guangdong, 518054, China
Tel
：
+86(755)86226969
Fax:
：
+86(755)86223939
Embedded box
Base
main body
Bus and coding
interfaces
Indica
tor
Lever
Special tools
Wall
