Multipoint
A2DP
Connection
headphone
can
connect
to
two
phones(
（
iPhone6s
、
SamsungS6)
Redial last
number
Double click
power button
Double click power button can do redial last
number
RED LED flash
fast
in
an
alternating
pattern
(200mS)
Charging
When in charging, the red LED will be always on; once the energy is full,it will go
off
Line in
When the Audio cable is plug in, the headphone will play music in line-in
mode(the headphone will power off automatically)
low battery
When power is low, then there will be a
voice prompt “dududu”, while the RED
LED flashes twice per 5second at music-playing mode (flashes once per 5s at
other mode)
—this alarm will occur in every 3minutes, and it will lasts about 3-5
times until the headphone power off automatically.
Pairing the headphones with a computer
1.Before pairing the headphone with your computer, please
make sure your computer or laptop can
support bluetooth function. If not, you must
purchase a bluetooth adapter
(preferably version 2.1 or above).
2. Insert the bluetooth adapter to the computer, and make sure the bluetooth function of the computer is
already activated.
3. Press the power button about 5s when the headphone is at power off status. It will go into paring mode
when the blue and red LED light flash alternately, while you can also hear a prompt
4. Open the bluetooth software and choose to search the bluetooth device, and after few seconds, the
names of bluetooth device will list out.
6. Click the pairing name “Taotronics TT-BH040”to pair, when there is a prompt “beep”, this means your
headphone is paired successfully .
FCC NOTICE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,