SHELTER SSC150905, Assembly Manual

Page: 11 / 36

2013GK8005
-10-
C--Cover Installation
1. There are three parts for the cover, which are front cover with front panel, mid cover and
back cover with back panel (No.I1, I2 and I3). They are connected by the supplied rope
(No.O) as Figure 1 shows.
2. Insert the square tensioning tubes (No.G1-A, G1-B, G2 and G3) into the Roof cover pipe
pockets and fix them by the “L” shaped stakes (No. J), then tension the cover. Each
tensioning tube is equipped with 3pcs of stakes for sidewall and front and back panel.
D—Overhead Door Installation
Please refer to the instruction for detail information.
1.
The side track and the vertical track have been riveted together. Install the side track to
front door frame (No.D1L and D1R) by self drilling bolt.
2. Install the horizontal curve track to rafter (No.B2) using perforated angle. Then connect
it to the vertical track by bolt.
3. Install the balance system.
4. Install the door panels and door hardware.
5. To adjust the whole door.
6. To install the motor.
NOW THE INSTALLATION IS FINISHED
Figure 1