Charging
Do not use power cord other than the one supplied with the skin enhancer as this may cause a
malfunction. Be sure to charge the unit before using it. Please use plug supplied in your package.
The charging indicator will blink while the unit is charging. When the unit is completely charged
(approximately 2 hours) the blinking will stop.
There is a power indicator in the top left corner when the unit is turned on. This will indicate how
much power is left in the unit. Please do not leave the unit continually plugged in when not in use.
This can shorten the life of the unit. When not in use for long periods of time, please charge the
unit every 3 month. This will increase the longevity of the unit.
Product Specs:
1. Product Name Skin Enhancer
2. Product size: 189*40*60
3. Product net weight: 250g
4. Rated input: AC100V-240V,50/60Hz.
5. Output voltage/current: DC5V1.0A
6. Rated power: 3.5W
7. Rated voltage/rated capacity: 3.7V/1200mAH
8. Charging time: approximately 2 hours.
9. Intensity Levels: 5
10. EMS/Microcurrent power is 5mW, current is 0.3mA
11. Ultrasound frequency is 600KHZ
12. Vibration frequency is 5000rpm
Twice Weekly Treatment Use
Begin in ultrasonic cleansing mode with your cleanser. If you wear base makeup, we suggest you
do step two of the cleansing mode. Seep. (Refer to explanation of skin enhancer modes section).
Next choose Lift mode. Apply hydrating conductive product to half of your face. Using upward and
outward movements use the Skin Enhancer for 5 minutes (unit automatically turns off after 5
minutes). Now choose Restore mode and use it for 5 minutes. You may need to add a bit of water
on top of product already applied to face.
Apply product to the second half of your face and repeat.
If wanted: Use Eye mode for 60 to 90 seconds around each eye. This mode is also very good for
around the lips.
Do not remove product. Finish off your treatment in cold mode for 60 to 90 seconds. This will lock
in the moisture for more hydrated looking skin. Apply sunscreen if doing this in the morning.
5 Day Intensive Repair Treatment
Follow the above protocol for your 1st treatment. For the next 3 days do the same protocol except
without
cleansing mode. On day 5 do the same protocol but
include
cleansing mode once
again. You may do this 5-day intensive once a month instead of doing 2 treatments a week.
