Note:
•When transmitting over long distances, the audio signal becomes weaker and
interference increases.
•If the source signal is too weak for reception, the transmitter automatically
switches off after approximately four minutes to protect the unit and save power.
If the source signal returns to an adequate level, the transmitter automatically
switches back on.
Remote Control
The remote control can be used to operate speaker Power, Auto Tune and
Volume functions.
1. To operate the speakers using the remote control, turn the remote over and
open the battery compartment cover located underneath.
2. Insert two AAA alkaline batteries (purchase separately) into the battery com-
partment, observing /- polarities as indicated.
3. Replace battery compartment cover.
Note:
The ON/OFF button on the remote control does not function as the primary
power switch for the speakers. To operate the ON/OFF function by remote
control, speaker power must be switched on first. (See Power Off.)
Power Off
To switch off power, press the
ON/OFF
button on the front panel of the speakers.
The LED light turns off. Power may also be switched off from the remote control.
When you use the remote control to power off, the speaker will switch to Standby
mode for five minutes. The LED changes from blue to green. To switch speaker
power on during Standby mode, press the
ON/OFF
button on the remote control.
If no signal is detected from the remote control for five minutes, the speakers
automatically switch off. If the transmitter detects no signal for approximately
4 minutes, the unit switches off automatically.
Volume Control
To adjust speaker sound level, press the
+/-
buttons located on the front panel of
each speaker until the desired volume is reached. The volume level may also be
adjusted from the remote control.
Speaker Operation
9
