13
English
1.
Place Canister Steam Cleaner on a flat, level surface.
2.
Make sure Power Button is OFF (Heating Indicator Light will not be illuminated) and
grounded power cord is unplugged from electrical outlet.
If unit has been in use, always use the following safety precautions before
removing the Reservoir cap to add water:
•
Allow unit to cool for 30 minutes.
•
Press and hold Steam Trigger to release ALL remaining steam.
WARNING:
Failure to follow these precautions may result in burns from escaping steam
when the Reservoir Cap is removed.
3.
Cautiously unscrew and remove Reservoir Cap.
4.
Drain any water remaining inside Reservoir.
NOTE:
The Reservoir should be emptied after each use – this will help minimize mineral
build-up and prevent over-filling.
5.
Using the Measuring Cup & Funnel, fill the unit with 54 oz (1,597 ml) of water.
NOTE:
In order to significantly reduce mineral build-up and prolong the life of your Canister
Steam Cleaner, use of distilled or de-mineralized water in the unit is highly recommended.
Refer to Page 16 for more information about mineral build-up.
WARNING:
Caution should always be used when pouring water into the Reservoir. Do not
look directly down into fill hole when filling. Keep your free hand and any children or pets at
a safe distance.
6.
Replace Reservoir Cap, ensuring that it is screwed on tightly to prevent hot steam from
escaping and causing injury.
CAUTION:
Only water should be used in unit, other chemicals or cleaning agents may
cause internal damage.
FILLING WATER TANK
