• Do not subject the units to extremely severe temperatures - DO NOT PLACE UNITS INTO
OVENS, FREEZERS or MICROWAVE UNITS.
NOTE: Opening the housing (other than the battery compartment) of the Remote Sensor
or the Clock Radio Time & Weather Butler
Unit will invalidate your warranty. Do not
attempt to repair this unit - There are no consumer serviceable parts.
TROUBLE SHOOTING
If Indoor and Outdoor temperatures do not match when placed next to each other:
The sensor is manufactured to be +/- 2 degree in accuracy under normal conditions. So it is
possible to have up to four degrees difference shown on the separate temperature sensors
(one could be “+2 degree” and the other “-2 degree”. Additionally, the calibration curve is
different between the two units because of the greater temperature range of the outdoor sensor.
Errors are usually noted on the extreme ends of the temperature ranges.
If Clock Radio Time & Weather Butler
unit is not accepting remote transmissions:
The
units may not be properly synchronized or the batteries may need to be replaced. See “USING
OUTDOOR TEMPERATURE” section for detailed instructions. With the two units next to each
other, attempt synchronization. Remember to always place the remote sensor within the
effective transmission range and away from large metal surfaces.
What is the recommended battery type?
We recommend using only alkaline batteries.
Where can I mount the remote sensor?
To get accurate readings and to prolong the life of
your sensor, we recommend that you mount it out of direct sunlight and rain. Fog and mist will
not affect the sensor, but large volumes of soaking rain may. To guard against this, we
recommend that you mount it under the eve of your house, your garage or any other suitable
place that will keep it out of direct sun and rain. Modifications not authorized by the
manufacturer may void users authority to operate this device.
If Outdoor Temperature Reading shows “- -”:
This may indicate a low battery or out of
transmission range.
SPECIFICATIONS
Range of temperature measurement:
Indoor temperature: +32° F to +122° F (0° C to + 50° C)
Remote sensor: -4° F to +140° F (-20° C to +60° C)
Transmission: Max. 100 ft. (30 m) Open area, RF434 MHz
