4. Select “2 RECEIVE” on the receiving unit.
2. Display the
TO
menu on the
unit.
5. Select SEND” on the sending unit.
(Make sure that both the sending and receiving units are set to the
same mode.)
3. Display the “UNIT TO UNIT” menu on the sending unit.
(Data transfer between the
units will begin.)
l
After the data is transferred, verify it with the “VERIFY” function to
make sure that it was transferred correctly.
l
When the receiving unit does not have sufficient memory capacity
to hold the data
transferred, “MEMORY FULL” will appear. If
this occurs, press
, delete any unnecessary items in the
memory of the receiving unit, and then retransfer the data.
4. Select VERIFY” on the receiving unit.
3
I
5. Select SEND” on the sending unit, which initiates data verifica-
tion.
The VERIFY function can be used to see if the data has been trans-
ferred correctly. The process for verifying transmission is almost iden-
tical to the sending process.
Either Organizer can be designated as the receiving unit during
verification.
Verifying one item of data
Recall the data to be verified and select “VERIFY”.
l
Verifying all the data in one operation mode
Recall the initial display for the mode to be verified (e.g., in the
SCHEDULE mode, recall the date input display) and select
“VERIFY”.
For example,
to verify all the data in the
mode:
Recall the initial display for
on the sending unit.
When the data in the receiving unit and sending unit do not
match up, an error occurs. If this occurs,
the data. If
the error message still appears, retransfer the data.
The CE-220T Data Transfer Cable is required.
When data is transferred, it will be appended to
data in the
receiving unit.
l
Transferring one item of data
Display the data you wish to transfer, and transfer it with the
“SEND” and “RECEIVE” functions.
l
Transferring all the data in one operation mode
Recall the initial display in the mode you would like to transfer
(in the SCHEDULE mode recall the date input display by
pressing
twice) and select the “SEND” and “RECEIVE”
functions.
During data transfer, secret data (coded with
is also
But, if the secret function is ON, an error will occur.
(“NAME
will appear on the display.)
Summary of Contents for ZQ-5000
