E-39
ENGLISH
XL-UH220H
XL-UH220H (BK)
XL-UH222H
References
Troubleshooting chart (continued)
Before transporting the unit
Remove all CDs from the unit. Make sure there is no CD in the disc
tray. Then, set the unit to the power stand-by mode. Carrying the
unit with discs left inside can damage the unit.
Care of compact discs
Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD
collection and player.
Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
Keep your discs away from direct sunlight, heat, and excessive
moisture.
Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.
Maintenance
Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.
Caution:
Do not use chemicals for cleaning (petrol, paint thinner, etc.). It
may damage the cabinet finish.
Do not apply oil to the inside of the unit. It may cause
malfunctions.
Specifications
As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification
figures indicated are nominal values of production units. There may
be some deviations from these values in individual units.
General
Amplifier
NO
YES
Correct
Power source
AC 230 V, 50 Hz
Power
consumption
Power on: 100 W
Power stand-by: 0.6 W(*)
Dimensions
Width: 175 mm (6-3/4")
Height: 240 mm (9-1/2")
Depth: 315 mm (12-1/5")
Weight
5.3 kg (11.7 lbs.)
( * )This power consumption value is obtained when the
demonstration mode is cancelled in the power stand-by mode.
Refer to page 10 to cancel the demonstration mode.
Output power
PMPO: 364 W
MPO: 182 W (91 W + 91 W) (DIN 45 324)
RMS: 100 W (50 W + 50 W) (DIN 45 324)
RMS: 76 W (38 W + 38 W) (DIN 45 500)
Output terminals
Speakers: 6 ohms
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Subwoofer pre-out (audio signal):
200 mV/10 k ohms at 70 Hz
Input terminals
Video/Auxiliary (audio signal):
500 mV/47 k ohms
