Sharp XG-NV1E, Service Manual

Page: 14 / 66

XG-NV1E
XG-NV1EA
14
4. Removing the PWBs
4-1. Remove the two screws that fix the PC terminal cover to the bottom cabinet.
4-2. Remove the two screws off the output shield. Take out the output shield and disconnect the R-LCD, G-LCD
and B-LCD connectors (RP, GP, and BP).
4-3. Remove the four screws off the output unit. Disconnect the insulating barrier, the ground leads and the
connectors (FN, Q, LL, FF, LF, BL, RC and EA). Pull up and away the output unit and the signal/PC terminal/
video board unit.
4-4. Peel off the shield sheet. Remove the four screws off the video board unit. Pull the unit toward yourself to
take it out.
4-5. Remove the two screws off the back of the output unit. Separate this unit from the signal/PC terminal unit.
4-6. Remove the screw off the bottom cabinet and the screw off the power panel. Now take out the power panel.
4-1
4-1
4-3
4-3
4-2
4-5
4-4
4-6
4-6
Insulating
Barrier
Output Unit
Signal/PC Terminal
Unit
Output Shield
Power Panel
PC Terminal Cover
Shield Plate
Video Board
Unit