Sharp WF-2000W, Service Manual

Page: 8 / 24

WF-2000W
– 8 –
NOTES ON SCHEMATIC DIAGRAM
• Resistor:
To differentiate the units of resistors, The symbol as K and
M are used: the symbol K means 1000 ohm and the symbol
M means 1000 kohm and the resistor without any symbol
is an ohm resistor. The resistor designated “Fusible” is a
fuse type resistor.
• Capacitor:
To indicate the unit of capacitor, a symbol P is used: this
symbol P means pico-farad and the unit of the capacitor
without such a symbol is microfarad. As to electrolytic
capacitor, the expression “capacitance/withstand voltage”
is used.
(CH),(RH),(UJ): Temperature compensation
(ML): Mylar type
(S): Styrol type
• The indicated voltage in each section is the one measured
by Digital Multimeter between such a section and the
chassis with no signal given.
• Schematic diagram and Wiring Side of P.W. Board for this
model are subject to change for improvement without prior
notice.
SW2 TAPE 1 PLAY ON—OFF
SW3 TAPE 1 FF/REW ON—OFF
SW4 TAPE 1 REC ON—OFF
SW5 TAPE 2 PLAY ON—OFF
SW6 TAPE 2 FF/REW ON—OFF
SW101 BAND SELECTOR SW2—SW1—MW—FM
SW202 BEAT CANCEL A—B
SW203 DUBBING SPEED/MIC/ HIGH—NORMAL—MIC/
FM MODE FM STEREO—FM MONO
SW401 X-BASS ON—OFF
SW501 FUNCTION SELECTOR CD/LINE—RADIO—
TAPE/STAND-BY—ON
SW601 VOLTAGE SELECTOR 110-127 V—220-240 V
REF. NO.
DESCRIPTION POSITION
FITTING OF DIAL POINTER
A B
C
Figure 8-1
1. Remove the Main PWB, the Graphic Equalizer PWB and
the Fine Tuning PWB. (See Figure 4-2 in the "Disassem-
bly" on page 4.)
2. Remove the dial pointer guide and PWB.
3. Insert the dial pointer from , lead it under , hang it on
the tuner gear and then pass it through .
4. Replace the Main PWB, the Graphic Equalizer PWB and
the Fine Tuning PWB.
5. Rotate the tuning knob in the arrow direction until it stops.
(Set the tuner variable capacitor to "0" point (F-LOW
state).)
6. Adjust the dial pointer so that its stopper becomes the
Figure 8-2 position. (Adjust the engagement of the pointer
gear and the tuner gear to get the minimum space between
the PWB and the stopper.) This position is the "0" point.
7. Screw up the PWB and the dial pointer guide.
Figure 8-2
Tuning Knob
Front Cabinet
C
A
Dial Pointer(207)
Tuner
Gear
PWB
Dial Pointer Guide
(256)
Main PWB
Graphic Equalizer
PWB
Fine Tuning
PWB
Screw(605)
ø3x8mm
B
Dial Pointer(207)
"0" Point
Tuner Gear
Stopper
Main PWB
Variable Capacitor
Dial Pointer
PWB
Make the minimum space.
Front Cabinet
Pointer Gear
• Parts marked with “ ” ( ) are important for
maintaining the safety of the set. Be sure to replace these
parts with specified ones for maintaining the safety and
performance of the set.