Sharp VL-H400X, Operation Manual

Page: 51 / 53

Before calling for service, please check the following troubleshooting table.
l
Power
l
No power
l
Recording
l
Operating time of
battery is short.
l
Power on but no
on the monitor.
l
Cannot record
I
l
Poor colour
l
Fuzzy
l
IS
too
dark.
l
Playback
l
picture not
easy to see.
l
No image appears.
l
Poor colour
l
The Infrared remote control does not
function.
l
Cassette cannot be Inserted.
l
Cassette won’t eject.
l
No tape movement Fast Forward
mode.
l
No tape movement mode.
l
Safety devices are
l
The battery pack
IS
not charged.
The power source not correctly
connected.
l
Depleted battery pack.
l
Dew in
l
Battery pack needs refreshing.
l
the AC adaptor cord. then, plug
the wall outlet 13)
l
Charge the battery pack
1
(Page
l
Connect the power source correctly
(Page 13. 14)
l
Use a charged battery (Page
l
dew dries
1
l
Refresh battery pack. (Page
l
IS
VCR mode.
l
the OPERATE to CAMERA.
l
Erasure protection hole
IS
covered.
l
the red to open the hole
l
not properly adjusted.
l
Adjust the (See operation
l
balance is set improperly
l
Poor lighting.
l
Reset the balance or set the
to
Full Auto
mode (Page
l
Apply or correct
of
l
Dust or other matter on lens.
l
Clear lens
l
Not properly focused.
l
Adjust the focus or set the to
l
High speed shutter
IS
set to
speed mode.
l
picture adjustments
Auto mode (Page
l
Set the to Auto mode
(Page
l
Adjust !he
l
Improperly connected to
l
Reconnect properly (Page
l
channel or
IS
l
Tune to RF converter’s output channel
not properly set. (VHF channel 0 or 1). (Page 44)
l
AV terminal mode
IS
set to Input.
l
Set TV’s to VIDEO
the
IS
used. (Page
. Change the terminal to
l
balance not properly adjusted
l
sure the balance
IS
properly
during recording.
adjusted recording. (Page
l
Dirty video heads
l
service
l
Worn heads
l
Carl for
l
Old or worn tape Use a new tape cassette (Page
. The lithium battery has run down.
l
The remote control
IS
beyond range.
l
Intense
IS
on the
photoreceptor.
l
There
IS
an obstacle between the
remote control and the
photoreceptor.
l
Cassette
IS
not right up or
IS
backwards.
l
Replace the battery a new one
(Page 1)
l
Use the remote control
range. (Page 23)
l
daylight fall on the
photoreceptor (Page
l
Remove the obstacle or use the remote
control from a different (Page
l
Check cassette and
(Page
l
Another cassette
IS
the
l
is in Camera Recording mode
l
Press the EJECT remove
(Page
l
Press REC START/STOP button to stop tape
and try (Page 22)
l
Tape
IS
already completely wound.
l
to desired (Page 28)
l
Tape
IS
already completely rewound.
l
Fast to desired (Page
l
IS
a microprocessor. Its performance could be adversely external noise or Interference
should happen, turn off the power, and disconnect from any power sources, etc
reconnect the power sources (to resume operation).
l
If the characters displayed on the screen appear to disconnect the power source and remove the
battery, then reconnect the power source, insert the lithium battery, and turn the power on When the characters on the
monitor becomes normal, set the date and then resume