3
VL-E780U
VL-E785U
VL-E785T
4. DISASSEMBLY OF THE SET
4-2. Disassembly of the VCR main body
1. Removal of the VCR lid shaft
(1)Remove one screw ((j)LX-HZ0063TAFC).
Area A
(j)
4-3. REPLACEMENT OF CCD SENSOR
4-3-1. BEFORE REPLACEMENT
1) The CCD image sensor is more sensitive to electrostatic breakage than C-MOS LSI. Therefore sufficient means to
prevent electrostatic damage must be taken when it is replaced.
•
Ground the soldering iron.
•
Ground also the human body, using the wrist strap(through an 1 Mohm resistor).
•
Until the CCDsensor is mounted on the PWB, fit it to the conductive sponge, and short-circuit the foot lead.
2) Take utmost care so that the surface glass of CCD sensor and optical filter are not contaminated and damaged. If any
contamination is found, for example fingerprint, wipe it off with silicon paper or clean chamois skin.
3) When replacing the CCD sensor, use the antistaic grounded soldring iron, and perform quickly soldering.
JAPAN
SHARP
Index Mark
LZ2413H5
YYWWXXX
1
7
14
8
4-4. INITIAL SETTING OF E
2
PROM IC
4-4-2. IC702 (E
2
PROM)
When the IC702 has been replaced, make the following settings and adjustments.
1. Remove the backup battery (CR2025)
2. Turn power switch to CAMERA
3. Setting up the V ADJ mode as follows.
* After press the CONTINUE key, press the VCR ADJ key on service remote control (RRMCG0033TASA).
E780U
E785U
E785T
address
data
data
data
03
F8
FA
FE
0B
07
05
01
01
00
00
00
09
FF
FF
FF
04
00
00
00
0C
FF
FF
FF
02
01
01
07
0A
FE
FE
F8
