UX-340L/UX-345L
UX-330L
5. Externally connected TEL OFF HOOK detection circuit section
•
The circuit current detection is turned on together with OFF HOOK
of main body or OFF HOOK of externally connected TEL. ON of
CML OFF (HS=L) is judged as OFF HOOK of externally connected
TEL.
6. CI detection circuit
•
CI is detected by the photocoupler which is integrated in series in
the primary side TEL circuit well proven in the existing unit.
7. Signal/DTMF transmission level & receiving level
•
Signal transmission level setting: ATT -8 dB Circuit output: -11 dBm.
•
DTMF transmission level setting: HF -4.5 dBm LF -6.5 dBm
Thus, set the level.
Signal Name
Description
CML
Line connecting relay and DP generating relay
(The circuit is located
H: Line make
in the TEL/LIU PWB.)
L: Line break
Speaker tone mute control signal
SP MUTE
H: Muting (Power down mode)
L: Muting cancel (Normal operation)
Handset reception mute control signal
TEL MUTE
H: Muting
L: Muting cancel
Handset receiver volume control signal
RCVOL
(The circuit is located
in the control PWB.)
Note: The DTMF sending listed above is DTMF signal
sending in the handset OFF-HOOK mode.
Speaker volume control signal,
VOL A
VOL A VOL B matrix
VOL B
(The circuit is located
in the control PWB.)
TXCONT
Handset transfer mute control signal
(The circuit is located
H: Signal sending, when transmitting
in the control PWB.)
L: During reception, transmission mute,
(during standby)
GAIN-C
Reception gain switching signal
(The circuit is located
H: When connected to line, 1: 1 gain
in the control PWB.)
L: When not connected to line, HIGH gain
BZCONT
Speaker output signal switching
(The circuit is located
H: Buzzer signal output (during stand by)
in the control PWB.)
L: When monitoring line signal
RCVCL
Volume
DTMF/DP
H
Middle
Fixed/—
L
high
—
VOL A
VOL B
RING.
Buzzer
DTMF
Receiving
H
H
—
—
—
L
H
Low
—
Low
H
L
Middle
Fixed
Middle
L
L
High
—
High
4) Signal selection
The following signals are used to control the transmission line of TEL/
FAX signal. For details, refer to the signal selector matrix table.
[Control signals from output port]
5 – 9