65
page 49
Express Freezing cannot
be carried out
This product cannot carry out two express operations at the same time.
Express Ice Making cannot
be carried out
Is Auto Ice Maker set to OFF?
Start operation after setting Auto Ice Maker to ON.
The LCD panel display is OFF
It will light up by pressing one of the buttons.
" " display is
blinking slowly
Did you use the Warming mode?
The " " display will stop blinking once
the compartment cools down to "Fresh case" zone.
Foods in the
refrigerator compartment
freeze
Are succulent foods stored near the discharge port?
Foods may freeze since the top shelf is close to the discharge ports.
Is the temperature setting at Max?
The refrigerator compartment may also become too cold when the freezer compartment is
set to
Max
. In this case, return the setting of the freezer compartment to
Normal
.
Is the ambient temperature 5
°
C or less?
When the ambient temperature is low, foods may freeze even when the temperature
setting is at
Min
.
page 55
There is odor within
the compartment
Are foods with strong scents stored without wrapping?
We recommend use of a plastic wrap when using the Warming mode or
when storing food materials with strong scents in Express cooling.
Are you storing food materials with strong scents for a long period?
Did you leave the refrigerator power OFF for a long time?
It is impossible to remove
all odors even by the
nano deodorier.
The vegetable compartment
is not deodorized because
the cool air does not enter
the compartment directly.
The floor is wet
Vegetables become
dry soon
Is the door packing damaged?
Water may spill over from the evaporating pan when the door packing is
damaged as there is increase of condensation within the refrigerator.
Contact the Sharp Service Center for replacement door packing.
Are you storing vegetables that easily dry without wrapping?
Please use a plastic wrap to store.
Is the refrigerator tipped or moved?
If water remains on the evaporating pan (which cannot be seen from outside)
inside the refrigerator, it may become spilled on the floor.
It is the failure of heat release fan motor.
(It cannot be seen from outside.)
Though cooling operation will be continued, the cooling performance may deteriorate.
Although operation is accepted from the control panel even when this error is
displayed, the error display will return when it goes back to normal display.
The LCD panel shows
the following display.
The following occur during the production process and are not production defects. Please be assured and continue using the product.
Cracks or flaw-like lines on a plastic part
Small holes
(several on every door)
Dent
Lower part
of Refrigerator
compartment
Fresh case
Small hole on inside of door
Dent in plastic
Curve
There can be a flaw where more than one
cluster of plastic filled during part molding
meets together or on a die joint.
This is not a production fault and will not
lead up to a crack.
This hole was made to
release internal air in the
foaming process of the
door's insulation material.
A dent formed when the resin material injected at
time of component formation cools down and
shrinks. This does not affect strength of component.
