E-16
SD-AT1000H_SEEG_E.fm
03/3/14
SD-AT1000H
ENGLISH
2
3
4
5
6
7
8
1
TINSZ0943AWZZ
Pr
epara
tion f
o
r Us
e
- Se
tting the
c
loc
k
-
Setting the clock
By setting the unit to the correct time, you can use it not only as a clock but also for
timer playback.
You can set the clock even when the unit is in the stand-by mode.
In this example, the clock is set for the 24-hour (0:00) display.
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The "ADJUST" or time will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "ADJUST" is not flashing in step 1, step
2 (for selecting the 24-hour or 12-hour display) will be skipped.
To change the 24-hour or 12-hour display:
1
Press the CLOCK button and within 5 seconds, press the ENTER
button.
2
Press the or button to select the 24-hour or 12-hour display and
then press the ENTER button.
Note that this can only be set when the unit is first installed or it has been reset
(see page 33).
"12:00 AM" The 12-hour display will appear. (AM 12:00 - PM 11:59)
"AM 0:00" The 12-hour display will appear. (AM 0:00 - PM 11:59)
"0:00" The 24-hour display will appear. (0:00 - 23:59)
3
Press the or button to adjust the
hour and then press the ENTER but-
ton.
"
Press the or button once to advance the time by 1 hour. Hold it down to
advance continuously.
"
When the 12-hour display is selected, "AM" will change automatically to "PM".
4
Press the or button to adjust the
minutes and then press the ENTER
button.
"
Press the or button once to advance the time by 1 minute. Hold it down
to advance continuously.
"
The hour will not advance even if minutes advance from "59" to "00".
"
The clock starts from "0" second (seconds are not displayed).
"
The time disappears after approx. 5 seconds.
1
Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on
page 33 for details.]
2
Perform "Setting the clock" from the beginning.
